Zortrax M200 Plus print examples

I am getting the hang of my new 3D printer. So I’m posting the photos I promised. First is a comparison: The darker green wererat on the left is with the new printer, compared to the neon green on the right with the old printer. So, yes, for my miniatures the new printer is working fine, and better than the old one.

Next is an example of something my old printer frequently refused to do: Print half a dozen miniatures at the same time. The new one did these 6 bandits in one go without problems. I assume it has to do with the ABS printing hotter, so it still sticks to the previous layer even that layer has been printed a while ago.

The other advantage of ABS is that you can treat it with acetone vapors, which makes the surface glossy and hides imperfections. As an example the 3DBenchy model printed twice identically, with the right one being treated with acetone vapors for 1 hour. Note that for miniatures you better just use 15 minutes, after 1 hour fine parts like arms or swords tend to melt.

Finally I used a model of a bard with a lot of detail to see how it comes out. This is with 15 minutes acetone treatment. Looking closely you can still see the layers and imperfections. But remember that this is just 3 cm tall, so for this size this is as good as it gets. You can see the lute, the rapier, and even the jester’s hat is printing out fine.